Hot Swap SATA Guide Page 4

Roll Your Own Hotswap SATA Guide

Guide and photos by Rick Stephens


 Last step, install the drives in your trays. Unlock the tray, flip the lever open and pull ’em out. Pop the cover off the tray and slip your drive in aiming the data and power connectors on the drive at the mating connections in the tray. Slide the drive back all the way to the rear to make full contact. Hold the drive in place and flip the tray over.

Drive Tray

Hard Drive

  Using the four coarse screws included with the hotswap trays (size 6-32) attach the drive to the tray from the bottom.

Attach drive to tray

 Slip the cover back on and slide your completed trays into the Burly enclosure for a completed job.

Completed Burly

 Marvel at your creation. Ready to rock and roll, absolutely perfect!


CloseUp of Burly

MacGurus Seal

The Gurus Certify These Instructions Work!

Your Cart
Your Cart: Empty
© 2023 MacGurus, all rights reserved worldwide.
Software: Kryptronic eCommerce, Copyright 1999-2023 Kryptronic, Inc. Exec Time: 0.036899 Seconds Memory Usage: 1.685486 Megabytes