good morning all.

well i've finally gotten around to actually setting up a X10 home automation controller out of my trustly old se/30.

my question is this... does anyone know of any exhaustive ram/processor/hardware testing software (similar to power ctrl/frax) that i could run on a overnight basis to check for any reliability issues.

i suppose a worst case scenario is to let it chew on afterdark modules for a while but i was hoping for something a little more intense.

thanks
kj

ps: anyone tried to plug a daystar turbo 040 into the pass thru of a se/30 ethernet card or is this problematic. ofcourse space considerations aside (i found a pds extension card that rise six inches at fry's, appears to be same slot connection as mobo).