PDA

View Full Version : Burley Bay Enclosure Not Showing on "New" MacPro (2009)



hapycampr2002
11-04-2019, 07:26 AM
I purchased a refurbished 2009 MacPro recently to replace my previous MacPro. I switched out the board for my 4-bay Burley Enclosure from my old MacPro to my recent one. I am now not seeing my drives in the enclosure. Rebooted but didn't help. Any suggestions? Thank you!

ricks
11-04-2019, 08:56 AM
Does your eSATA host card require a driver?

hapycampr2002
11-04-2019, 10:51 AM
Does your eSATA host card require a driver?

Thanks! That is a good question. I don't recall. I purchases the bay drive & card from MacGurus. If so, is it possible to download the driver?

ricks
11-04-2019, 10:54 AM
You need to know what card you have. Then I can answer that. Search your mail and we can proceed from there.

Rick

ricks
11-04-2019, 11:05 AM
Or look in System Profiler and see what card is installed. Post the number here. Along with which Mac OS you are running.

hapycampr2002
11-09-2019, 09:21 AM
Or look in System Profiler and see what card is installed. Post the number here. Along with which Mac OS you are running.

Thank you! Here is card info:

pci1095,3132:
Type: Other Mass Storage Controller
Driver Installed: No
MSI: No
Bus: PCI
Slot: Slot-4
Vendor ID: 0x1095
Device ID: 0x3132
Subsystem Vendor ID: 0x1095
Subsystem ID: 0x3132
Revision ID: 0x0001
Link Width: x1
Link Speed: 2.5 GT/s

hapycampr2002
11-10-2019, 07:20 AM
Or look in System Profiler and see what card is installed. Post the number here. Along with which Mac OS you are running.

Hi. I forgot to include what OS I have. It is OS X 10.13.6, High Sierra. This is the card info:
pci1095,3132:
Type: Other Mass Storage Controller
Driver Installed: No
MSI: No
Bus: PCI
Slot: Slot-4
Vendor ID: 0x1095
Device ID: 0x3132
Subsystem Vendor ID: 0x1095
Subsystem ID: 0x3132
Revision ID: 0x0001
Link Width: x1
Link Speed: 2.5 GT/s

ricks
11-11-2019, 10:01 PM
Well, you will need a new card. That card is based on Silicon Image chipset. Silicon Image went away in 2008. Just luck that the latest driver, which I think was for Yosemite, worked up through Mavericks. After that, nada. And no new drivers will be written.

The later model Lycom 4 port card runs off of AHCI built in drivers. Makes it a very agnostic card as far as what operating system - everything uses AHCI drivers.

Rick

sorry I was gone today. On the road, all day.

hapycampr2002
11-13-2019, 10:30 AM
Thank you for your help Rick. I have ordered a new card. Much appreciated.