View Full Version : Help! My IXMicro Video Card Failed After Zapping PRAM

04-21-2002, 09:41 AM
I have a PowerCenter Pro running OS 8.6 with a IXMicro Ultimate Rez video card installed. I recently had to zap the PRAM and immediately lost video resolution and color balance. In addition, on opening the IXMicro Video Control software I see only the marquee with everything else blank. As a result I have no control over the card. I have tried removing the video card, rebooting, powering down and then reinstalling the card as suggested on xlr8yourmac.com. Didn't help, nor did reinstalling the v 2.0 IXMicro software. Anyone have any idea what the problem might be?

04-21-2002, 09:55 AM
Is there a CUDA reset button on the motherboard ? If so holding it down fo
about 30 seconds may help. I suspect it may be time for a new battery..M

04-21-2002, 12:08 PM
I did hold down the CUDA for 30 sec. when the board was out, and the battery was replaced fairly recently, so my problem is something else.

04-21-2002, 04:11 PM
Does Apple System Profiler properly identify you card? The card's name should appear as "IMS,tt3d"


04-22-2002, 05:55 PM
Yes, the System Profiler identifies the IXMicro card correctly.

04-23-2002, 02:30 AM
What control over the monitor do you have in the Monitors control panel? I would avoid using the IXMicro control panel for anything in Mac OS 8.5 or later.