270 degree SATA cable

  Super low profile for clearance in the tightest places. The 270 degree connector on one end faces UPWARDS when installed on a drive.

  Perfect cable for mounting on the floor of all Mac hinged door towers - from B&W through all G4 towers.

  Useful in many PCs where low profile end routed towards drive label is needed. Cable goes away from leg on connector.

  Supports SATAI, SATAII and SATAIII specification

270 degree cable shown connected to a drive. Note that cable faces upwards towards drive label.

  90 Degree one end, straight other end. The 90 degree cable end faces down towards drive's printed circuit board when connected to a hard drive. Many drive locations or SATA host card adapters can use these cables to clear obstructions. Please check your specific computer drive and host connections to determine your needs.

  Cable goes towards leg on connector.

  Meets SATAI, SATAII and SATAIII specification.

Non-Latching

Installed on Drive

Latching Cable

Power Adapters and Cables

1 Meter Shielded Type A External Data Cable

Solving the interference problems sometimes seen with using data cables meant for internal use, these shielded cables are the right way to hook up your external SATA enclosure. Triple shielded with an extra heavy PV outer sheath for tough wear. These cables are very flexible. These set the standard for external SATA cable needs. These cables are Type A to Type A connections.

 Meets SATAI and SATAII specification.

1 and 2 Meter eSATA to Internal SATA Shielded Data Cable

These cables are for connecting eSATA device to anything with the 'L' shaped internal conector. Or attaching an eSATA Host Card to any device with an internal 'L' type connector.

The internal SATA connector with the 'L' shape is the same connection as that of your hard drive. Meets SATAI and SATAII and SATAIII specifications.

1 and 2 Meter eSATA to eSATA Shielded External Data Cable

These cables are for connecting eSATA device to an eSATA Host card. Both ends are the same. These cables support 3Gb/sec SATAII specification as well as SATAI.

Single and Double Cable PCI brackets

Connect your internal SATA host to external PCI ports giving a clean, safe and sturdy attachment for external cables. External connector in eSATA. SATAI and SATAII capable. All internal connectors are 'L' type

SATA Male to Female jumper cable and Centronics opening Bracket

Convert your old SCSI enclosure to SATA! The jumper cable attaches with screws to the Centronics bracket which is sized to fit the Centronics opening in the back plane of most SCSI drive enclosures. Use the 12 inch and 18 inch versions to convert most multi-drive enclosures. The 6 inch cable is useful in smaller single drive enclosures.

These cables are SATAI and SATAII capable. eSATA external connectors are available for the female chassis mount end. Male end is always TypeA which matches internal host card or hard drive connectors.

SATA Power and Data Combined Drive Cable

A combined power and data cable assembly for the cleanest installation possible. More secure, this cable connects to the 7 pin data and 15 pin power connector on the drive and has separate 18 inch data cable and 8 inch power cable to 4 pin molex connector. Available with TypeA external connectors ONLY.